Jinzhou Sata Fused Fluxes and New Materials Factory.
Cover Flux
Cover Flux
Cover Flux
  • Cover Flux

Cover Flux (SATA-PF-340)

General Description of Cover Flux (SATA-PF-340)

The aluminium melt is extremely easy oxidation and inhale when it is in melting. A flux is required to have low melting, low density, good humidity, and can form a dense uniform protective film, which we called it cover flux.
SATA-cover flux is used for covering of molten aluminium, it can form a cover layer on the surface of molten for prevent the molten aluminium react to oxidation.

Application of Cover Flux (SATA-PF-340)

  • Use Instruction: it can added at one time before refining or it can added in two batches,first add half cover flux to the molten aluminium and stir the melt and make the flux fully react to molten, then skimming the dross and spread the balance on the surface of the aluminium molten.

Advantage of Cover Flux (SATA-PF-340)

  • It can prevent the aluminium molten react with oxygen in the air.
  • It is a eco-friendly flux, less fume during working
  • It can separate the dross from aluminium molten, reduce metal loss
  • Low working temperature, suitable for kinds of furnace

Specification of Cover Flux (SATA-PF-340)

  • White mixed powder.
  • Aluminium melting temperature: 650-750℃.
  • Recommended Dosage: 1.5-3kgs/ton aluminium molten, 0.8-1.0kg/m2 of melt area. it should adjust according to the purity and air humidity.
  • Package:
  • Packed in 5kg (PE), 25kg (PP), 1000kg bags or customized
  • Stored in dry, well-ventilated place, and avoid direct sunlight,keep sealed before using.

Package of Cover Flux (SATA-PF-340)

  • Packed in 5kg (PE), 25kg (PP), 1000kg bags or customized.
  • Stored in dry, well-ventilated place, and avoid direct sunlight,keep sealed before using.

NOTE: This flux has serious hygroscopicity, please use immediately after opening.
See More
  • Cu Tablet

    Cu Tablet

    September 18, 2019Cu TabletGeneral Description of Cu TabletCu Tablet is used to adjust the content of Cu in Aluminium Alloy; it is made by metal powder and pure aluminium in proportion. Density:3.8-4.1g/cm3Content: met...view
  • Sodium Fluosilicate/Hexafluorosilicate (SSF)

    Sodium Fluosilicate/Hexafluorosilicate (SSF)

    September 28, 2018Sodium Silicfluoride,Sodium Fluosilicate General introduction: Chemical Formula : Na2SiF6 UN NO.: 2674 CAS NO.:16893-85-9 Off white crystalline powder Solubility: Soluble in water up to 1.45g/100ML a...view
  • Degassing Flux

    Degassing Flux

    September 6, 2019Degassing Flux (SATA-PF-350)General descriptionPractice has proved that the hydrogen is the main cause of the pores in the aluminium alloy, the pores not only reduce the actual cross-sectional area of...view
  • Dissolving Agent

    Dissolving Agent

    September 28, 2018General introductionIt is a compound smetling flux for magnesium and its alloy, to protect magnesium melt and accelerate the melting rate.fluxMain composition(%)MgCl2KClBaCl2CaF2NaClCaCl2MgOInsoluable Substan...view
Leave a Message Email Us

we will contact you within 24 hours.